Opticon 25-WEDGE-04 Uživatelský manuál stáhnout pdf (Strana 10)

Page 6

Troubleshooting

A. If LEDs do not light up when installation

instructions are followed:

 Make sure there is power to the system

 Recycle computer power

 Confirm computer fuses are ok.

 Check for loose cable connection

B. If the wand tip lights up, Good Read beep is

audible, but outputs random characters to

screen, verify that the wand has been pro-

grammed to the correct settings:

 Confirm selected Computer Type

matches the type of computer being used.

 Adjust Intercharacter Delay settings.

Intercharacter delay settings will vary

according to the computer type being

used.

 Is a dedicated file server being used?

Non-dedicated file serves may cause

problems for a Wedge interface. Opticon

recommends using an RS232C CCD smart

wand on non-dedicated file servers.

3. If the wand tip lights up, but Good Read

beep is not heard and no data appears on the

computer:

 Is the bar code label readable? Does it

meet bar code specifications?

 Does the smart wand read other bar code

labels? (If yes, the non-reading label may

be a label which the smart wand is not

programmed to decode.)

NOTE: If after performing these checks, the

smart wand is still not functioning, contact your

distributor or call Opticon Technical Support at

800-636-0090.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 46 47

Komentáře k této Příručce

Žádné komentáře